If air bleeding has not been performed, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1451 to prevent the entry of air due to pump motor operation.
DTC C1451 is stored when Motor Invalid is selected, the system will not return to normal until the air bleeding procedure is performed.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1451 | Motor Drive Permission Malfunction | 1152 | Either of the following is detected:
1.
Using the GTS, "Motor Invalid" of the "ECB Utility" has been performed. 2.
The brake booster with master cylinder assembly has been replaced. |
Air bleeding not performed | Electronically controlled brake system DTC
|
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
|
*: Electronically Controlled Brake System |
|||
| Diagnosis Condition | - | - | - |
| Malfunction Status | Using the GTS, "Motor Invalid" of the "ECB* Utility" has been performed. | ○ | - |
| The brake booster with master cylinder assembly has been replaced. | - | ○ | |
| Detection Time | - | - | |
| Number of Trips | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
Bleed the air from the brake system.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING
If air bleeding has been performed, this DTC will be cleared.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C1451 is output. | A |
| DTC C1451 is not output. | B |
A
B