The skid control ECU (brake booster with master cylinder assembly) outputs this DTC when it receives a sensor power source malfunction signal from the steering angle sensor.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1432 | Steering Angle Sensor Power Source Voltage | 703 | Steering angle sensor power supply malfunction signal is received from steering angle sensor. | ·
Wire harness or connector ·
Steering angle sensor |
VSC DTC |
Refer to DTC C1434.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1434
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Front view of wire harness connector
(to Steering Angle Sensor) |
Remove the steering wheel and column cover.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Disconnect the F69 steering angle sensor connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F69-5 (BAT) - Body ground | Always | 11 to 14 V |
| F69-4 (IG1) - Body ground | Power switch on (IG) | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Steering Angle Sensor) |
Turn the power switch off.
Measure the resistance according to the value(s) in the table below.
Before measuring the resistance of the steering angle sensor, turn the power switch off and leave the vehicle for 1 minute or more without operating the key or switches, or opening or closing the doors.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F69-1 (ESS) - Body ground | 1 minute after power switch off | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG