When ABS, TRC or VSC is operating, the skid control ECU (brake booster with master cylinder assembly) blinks the slip indicator light to inform the driver that slippage occurred.
When in VSC off mode, or TRC and VSC are disabled, the multi-information display in the combination meter assembly displays TRC OFF message and the VSC OFF indicator light illuminates to inform the driver.
When a communication malfunction with the hybrid vehicle control ECU is detected, TRC and VSC are disabled. Also when the system is malfunctioning, TRC and VSC are disabled and the indicator lights of related systems illuminate.
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
Check if the slip indicator light was illuminated when TRC did not operate.
The slip indicator light was illuminated.
When a DTC is stored, the slip indicator light is illuminated and TRC does not operate due to the fail-safe function.
Check the operation condition of the VSC OFF switch (electric parking brake switch assembly) when TRC did not operate.
The VSC OFF switch (electric parking brake switch assembly) had been operated to turn off TRC when TRC did not operate.
When the multi-information display in the combination meter assembly displays TRC OFF message, TRC does not operate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Turn the power switch off.
Turn the power switch on (IG).
Check the DTCs (electronically controlled brake system) that are output.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| Electronically controlled brake system DTCs are output. | B |
A
B
Operate the VSC OFF switch (electric parking brake switch assembly) and check that the multi-information display in the combination meter assembly displays TRC OFF message and the VSC OFF indicator light illuminates in accordance with the operation of the switch.
The multi-information display in the combination meter assembly displays TRC OFF message and the VSC OFF indicator light illuminates in accordance with the operation of the switch.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, perform a Test Mode (Signal Check) inspection sensor check and check that speed sensor Test Mode (Signal Check) inspection items change from incomplete to complete.
| Tester Display |
|---|
| Signal Check |
Speed sensor Test Mode (Signal Check) inspection items change from incomplete to complete.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Operate the VSC OFF switch (electric parking brake switch assembly) and check that the system is not in TRC off mode or VSC off mode.
Check that no DTCs are output and that each warning light is not illuminated.
Start off the vehicle on a low friction surface and check that TRC operates when attempting to make the drive wheels slip.
TRC operates when slip occurs when starting off.
Even when the system is normal, VSC may not operate when the vehicle speed is low or TRC may not operate due to a malfunction. Make sure that only the drive wheels slip during the procedure.
When confirming that the slip indicator light blinks, do not slip the drive wheels longer than necessary. Whether TRC operated or not can be checked by reading the Freeze Frame Data when the system operated.
Pay attention to your surroundings when performing the procedure and depress the accelerator pedal with caution.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C