Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH
RM32K0E _54 Brake _060044 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294932 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84390B 1.INSPECT VSC OFF SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (for LHD)

a.

Check the resistance.

i.
C366035C02
2.24,1.854 2.24,1.479 true 1.365,1.854 1.365,1.479 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 2.198,1.875 2.365,2.125 0.167,0.25 10 false E 1.333,1.875 1.5,2.125 0.167,0.25 10 false +
*a Component without harness connected
(VSC OFF Switch (Electric Parking Brake Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
13 (+) - 8 (E) Switch pushed Below 1 Ω
13 (+) - 8 (E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF switch (electric parking brake switch assembly).



Hide 84390B 2.INSPECT VSC OFF SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (for RHD)

a.

Check the resistance.

i.
C366035C05
2.24,1.854 2.24,1.479 true 1.719,1.854 1.719,1.479 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 2.198,1.875 2.365,2.125 0.167,0.25 10 false E 1.698,1.875 1.865,2.125 0.167,0.25 10 false +
*a Component without harness connected
(VSC OFF Switch (Electric Parking Brake Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
11 (+) - 8 (E) Switch pushed Below 1 Ω
11 (+) - 8 (E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF switch (electric parking brake switch assembly).