Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ACTUATOR
RM32K0E _54 Brake _060048 PARKING BRAKE _0294936 ELECTRIC PARKING BRAKE ACTUATOR G

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 46310B 1.INSPECT PARKING BRAKE ACTUATOR ASSEMBLY

HINT:

Using the GTS to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3 with the power switch off.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Electric Parking Brake / Active Test


e.

When the vehicle's tires are lifted off the ground and the GTS is used to operate the electric parking brake, check the condition of the rear tires.


f.

According to the display on the tester, perform the Active Test.

Chassis > Electric Parking Brake > Active Test
Tester Display
PKB Lock Control
50004 184 30
Chassis > Electric Parking Brake > Active Test
Tester Display
PKB Release Control
50004 184 31

If the result is not as specified, inspect the electric parking brake actuator.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>INSPECTION


g.

Turn the power switch on (IG), push the electric parking brake switch to the lock side for 1 second and check that the parking brake indicator light (red) illuminates.


h.

Also, check that the brake warning light / yellow (minor malfunction) does not illuminate at this time.