Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SWITCH
RM32K0E _54 Brake _060048 PARKING BRAKE _0294937 ELECTRIC PARKING BRAKE SWITCH G

PARKING BRAKE  ELECTRIC PARKING BRAKE SWITCH  INSPECTION  


PROCEDURE

Hide 84390B 1.INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY

a.

Check the resistance.

i.
C366035C09
1.583,1.198 1.417,0.5 true 1.76,1.198 1.917,0.5 true 1.948,1.208 2.5,0.5 true 1.323,1.198 0.656,0.844 true 2.104,1.208 2.75,0.833 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 1.01,0.375 1.49,0.615 0.479,0.24 10 false RLS1 1.958,0.365 2.438,0.604 0.479,0.24 10 false RLS2 2.552,0.385 3.031,0.625 0.479,0.24 10 false LOK2 0.24,0.75 0.719,0.99 0.479,0.24 10 false LOK1 2.792,0.75 3.271,0.99 0.479,0.24 10 false GND1
*a Component without harness connected
(Electric Parking Brake Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (LOK1) - 2 (GND1) ON (Lock) 2.2 Ω
Switch not operated 104.8 kΩ
3 (LOK2) - 2 (GND1) ON (Lock) 1.1 Ω
Switch not operated 5.8 Ω
5 (RLS1) - 2 (GND1) OFF (Release) 1.1 Ω
Switch not operated 5.8 Ω
4 (RLS2) - 2 (GND1) OFF (Release) 1.1 Ω
Switch not operated 5.8 Ω


If the result is not as specified, replace the electric parking brake switch assembly.



b.

Check the Illuminates.

i.
C366035C07
0.667,1.25 1.167,1.25 true 2.292,1.25 2.792,1.25 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 0.354,1.167 0.688,1.375 0.333,0.208 10 false ILL+ 2.844,1.167 3.177,1.375 0.333,0.208 10 false ILL-
*a Component without harness connected
(Electric Parking Brake Switch Assembly)


Apply auxiliary battery voltage to the electric parking brake switch assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 7 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the electric parking brake switch assembly.