Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › SFI SYSTEM › 2016.10–2019.09
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295698 SFI SYSTEM D

2ZR-FXE ENGINE CONTROL  SFI SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

HINT:
·

If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.

·

Freeze frame data is available in long and short forms.




PENDING FREEZE FRAME DATA


HINT:

Pending freeze frame data is stored when a 2 trip detection logic DTC is first detected during the first trip.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Select a DTC in order to display its pending freeze frame data.

Powertrain > Engine > Trouble Codes
50001 372
HINT:
·

Pending freeze frame data is cleared when any of the following occurs.

-

Using the GTS, the DTCs are cleared.


-

The cable is disconnected from the negative (-) auxiliary battery terminal.


-

40 trips with the engine fully warmed up have been performed after returning to normal. (Pending freeze frame data will not be cleared by only returning the system to normal.)


·

With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip detection logic DTC is detected in the first trip, the old freeze frame data will be replaced with the new data of the newly detected DTC in the next trip.



A251781E72
0.177,0.188 6.813,0.583 6.635,0.396 10 false When a DTC is detected in both the first and second trips but the system returns to normal from the third trip (2 trip detection logic DTC): 2.063,0.948 2.719,1.198 0.656,0.25 10 false (First Trip) 2.813,0.938 3.667,1.156 0.854,0.219 10 false (Second Trip) 3.75,0.938 4.479,1.188 0.729,0.25 10 false (Third Trip) 4.521,0.938 5.323,1.135 0.802,0.198 10 false (Fourth Trip) 1.177,1.5 1.74,1.74 0.563,0.24 10 false On (IG) 1.177,1.823 1.5,2.01 0.323,0.188 10 false Off 1.26,2.521 1.917,2.771 0.656,0.25 10 false Stored 1.26,2.802 1.719,3.188 0.458,0.385 10 false Not Stored 1.26,3.708 1.917,3.958 0.656,0.25 10 false Stored 1.271,3.948 1.729,4.333 0.458,0.385 10 false Not Stored 0.156,1.615 1.125,1.833 0.969,0.219 10 false Power Switch 0.146,2.625 1.156,2.979 1.01,0.354 10 false Pending Freeze Frame Data 0.146,3.813 1.031,4.25 0.885,0.438 10 false Freeze Frame Data 0.406,4.698 1.854,4.896 1.448,0.198 10 false : Malfunction detected 0.396,5.042 2.365,5.313 1.969,0.271 10 false : Malfunction not detected

A251782E60
0.208,0.219 6.854,0.688 6.646,0.469 10 false When a 2 trip detection logic DTC is first detected in the first trip and another 2 trip detection logic DTC is first detected in the second trip: 2.656,0.813 3.344,1.021 0.688,0.208 10 false (First Trip) 3.521,0.813 4.438,1 0.917,0.188 10 false (Second Trip) 4.573,0.813 5.26,1.021 0.688,0.208 10 false (Third Trip) 5.458,0.813 6.292,1.021 0.833,0.208 10 false (Fourth Trip) 1.635,1.448 2.323,1.656 0.688,0.208 10 false On (IG) 1.656,1.771 1.958,1.979 0.302,0.208 10 false Off 1.615,2.365 2.135,2.563 0.521,0.198 10 false Stored 1.625,2.625 2.063,3.125 0.438,0.5 10 false Not Stored 1.604,3.323 2.063,3.521 0.458,0.198 10 false Stored 1.615,3.531 2.052,4 0.438,0.469 10 false Not Stored 4.375,2.938 5.063,3.146 0.688,0.208 10 false Uploaded 0.5,1.552 1.417,1.771 0.917,0.219 10 false Power Switch 0.49,2.479 1.479,2.854 0.99,0.375 10 false Pending Freeze Frame Data A 0.469,3.417 1.5,3.771 1.031,0.354 10 false Pending Freeze Frame Data B 0.708,4.156 2.875,4.344 2.167,0.188 10 false : Pending malfunction A detected 0.698,4.604 2.885,4.865 2.188,0.26 10 false : Pending malfunction B detected 0.688,5.115 2.51,5.344 1.823,0.229 10 false : No malfunction detected



LIST OF FREEZE FRAME DATA


Powertrain > Engine
Tester Display
Vehicle Speed
Engine Speed
Calculate Load
Vehicle Load
Mass Air Flow Sensor
Atmospheric Pressure
Intake Manifold Absolute Pressure
Coolant Temperature
Intake Air Temperature
Engine Run Time
Heater Coolant Temperature Sensor
IG-ON Coolant Temperature
Initial Engine Coolant Temperature
IG-ON Intake Air Temperature
Initial Engine Intake Air Temperature
Battery Voltage
BATT Voltage
Throttle Position Sensor No.1 Voltage %
Throttle Position Sensor No.2 Voltage %
System Guard
Open Side Malfunction
Throttle Request Position
Throttle Sensor Position
Throttle Position Sensor No.1 Voltage
Throttle Position Sensor No.2 Voltage
Throttle Position Command
Throttle Position Sensor Open Position No.1
Throttle Position Sensor Open Position No.2
Throttle Motor Current
Throttle Motor Duty Ratio
Throttle Motor Duty Ratio (Open)
Throttle Motor Duty Ratio (Close)
Throttle Position Sensor Fully Closed Learn Value
+BM Voltage
Actuator Power Supply
Throttle Air Flow Learn Value (Area 1)
Throttle Air Flow Learn Value (Area 2)
Throttle Air Flow Learn Value (Area 3)
Throttle Air Flow Learn Value (Calculated Value)
Throttle Air Flow Learn Value (Atmosphere Pressure Offset Value)
Low Revolution Control
Engine Stall Control F/B Flow
Injector Cylinder #1 (Port)
Injection Volume Cylinder #1
Injection Volume
Fuel Pump/Speed Status
Current Fuel Type
EVAP (Purge) VSV
Fuel Lid SW
Target Air-Fuel Ratio
A/F (O2) Lambda Sensor B1S1
A/F (O2) Sensor Voltage B1S1
A/F (O2) Sensor Current B1S1
A/F (O2) Sensor Heater Duty Ratio B1S1
O2 Sensor Voltage B1S2
O2 Sensor Impedance B1S2
O2 Sensor Heater B1S2
O2 Sensor Heater Current Value B1S2
Short FT B1S1
Long FT B1S1
Total FT Bank 1
Fuel System Status Bank 1
Fuel System Status Bank 2
Ignition Timing Cylinder #1
Knock F/B Value
Knock Correct Learn Value
Idle Spark Advance Control Cylinder #1
Idle Spark Advance Control Cylinder #2
Idle Spark Advance Control Cylinder #3
Idle Spark Advance Control Cylinder #4
Mass Air Flow Circuit
Target EGR Valve Position No.1
EGR Step Position
Clogged EGR Port Imbalance Ratio
VVT Advance Fail
Intake VVT Hold Learn Value Bank 1
Intake VVT Change Angle Bank 1
Intake VVT OCV Control Duty Ratio Bank 1
Intake VVT Target Angle Bank 1
Catalyst Temperature B1S1
Catalyst Temperature B1S2
TC Terminal
MIL ON Run Distance
Running Time from MIL ON
Time after DTC Cleared
Distance from DTC Cleared
Warmup Cycle Cleared DTC
Distance Traveled from Last Battery Cable Disconnect
IG OFF Elapsed Time
Ignition Trigger Count
Misfire Count Cylinder #1
Misfire Count Cylinder #2
Misfire Count Cylinder #3
Misfire Count Cylinder #4
All Cylinders Misfire Count
Misfire RPM
Misfire Load
Misfire Margin
Catalyst OT Misfire Fuel Cut
Catalyst OT Misfire Fuel Cut History
Catalyst OT Misfire Fuel Cut Cylinder #1
Catalyst OT Misfire Fuel Cut Cylinder #2
Catalyst OT Misfire Fuel Cut Cylinder #3
Catalyst OT Misfire Fuel Cut Cylinder #4
Engine Start Hesitation
Low Revolution for Engine Start
A/F Learn Value Idle Bank 1
A/F Learn Value Low Bank 1
A/F Learn Value Mid No.1 Bank 1
A/F Learn Value Mid No.2 Bank 1
A/F Learn Value High Bank 1
Engine Cooling Fan
Coolant Water Route Switching Valve
Engine Speed Cylinder #1
Engine Speed Cylinder #2
Engine Speed Cylinder #3
Engine Speed Cylinder #4
Average Engine Speed of All Cylinder
Requested Engine Torque
HV Target Engine Speed
Actual Engine Torque
Engine Driving Time
Request Engine Run Time
Judge Time Engine Ignition
Judge Time Engine Output
Fuel Level
ISC Learning Value
ISC Learning
F/C for Engine Stop Req
Engine Independent
Racing Operation
Request Warm-up
Engine Independent Control
Electric Water Pump Target Speed
Electric Water Pump Speed
Active Grille Air Shutter Position