Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295700 CAMSHAFT OIL CONTROL VALVE G

2ZR-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A246904C06
0.122,0.095 0.323,0.262 0.201,0.167 10 *a
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.


b.

Check the operation.

i.
A332556C04
0.792,1.438 0.792,1.854 0.792,1.854 0.969,1.854 true 0.156,0.083 0.469,0.24 0.313,0.156 10 false *a 0.51,0.719 0.823,0.875 0.313,0.156 10 false *b 0.479,1.813 0.792,1.969 0.313,0.156 10 false *c 1.021,1.781 1.333,1.938 0.313,0.156 10 false *d
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)
*b When Battery Voltage Applied
*c When Battery Voltage Cut Off
*d Spool Valve


Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2, and check the movement of the spool valve.

OK:
Condition Specified Condition
Battery voltage applied Valve moves in left arrow direction shown in illustration
Battery voltage cut off Valve moves in right arrow direction shown in illustration


NOTICE:

Confirm that the valve moves freely and does not stick in any position.


If the result is not as specified, replace the camshaft timing oil control valve assembly.

HINT:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.