11101J
1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Put the engine in inspection mode (maintenance mode).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE
Start the engine.
Inspect the camshaft timing oil control valve assembly.
Enter the following menus: Powertrain / Engine / Active Test / Control the Intake VVT OCV Duty Ratio Bank 1 / Data List / Intake VVT Change Angle Bank 1.
| Active Test Display |
|---|
| Control the Intake VVT OCV Duty Ratio Bank 1 |
| Data List Display |
|---|
| Intake VVT Change Angle Bank 1 |
Read the Data List while performing the Active Test with the engine idling.
| GTS Operation | Data List (Intake VVT Change Angle Bank 1) |
|---|---|
| -100% to 100% | Varies by 70 DegFR or more |
If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.