Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295700 CAMSHAFT OIL CONTROL VALVE A

2ZR-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSTALLATION  


PROCEDURE

Hide 11101J 1.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly.

NOTICE:

Do not damage the O-ring.



b.

Temporarily install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

NOTICE:
·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.

·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.




c.
A394186C01
2.063,0.844 2.313,0.479 true 1.208,1.313 1.448,1.542 0.24,0.229 10 true *a 2.365,0.385 2.604,0.615 0.24,0.229 10 true *b
*a Torque Wrench Fulcrum Length
*b 10 mm Union Nut Wrench


Using a 10 mm union nut wrench, tighten the bolt.

Torque:
Specified tightening torque : 10 N*m (102 kgf*cm, 7 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

8.8 N*m (90 kgf*cm, 78 in.*lbf)




d.

Connect the camshaft timing oil control valve assembly connector.