Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295705 CRANKSHAFT POSITION SENSOR A

2ZR-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51443C 1.REMOVE REAR ENGINE UNDER COVER RH

a.
A390449

Remove the 2 screws, 6 clips and rear engine under cover RH from the vehicle.


Hide 11401G 2.REMOVE CRANKSHAFT POSITION SENSOR

a.
A375022

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.