Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295705 CRANKSHAFT POSITION SENSOR A

2ZR-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the crankshaft position sensor, check the O-ring.



b.

Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.

·

If the crankshaft position sensor has been struck or dropped, replace it.




c.

Connect the crankshaft position sensor connector.


Hide 51443C 3.INSTALL REAR ENGINE UNDER COVER RH

a.

Install the rear engine under cover RH to the vehicle with the 2 screws and 6 clips.