Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › KNOCK SENSOR
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295708 KNOCK SENSOR A

2ZR-FXE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

HINT:

Perform "Inspection After Repair" after replacing a knock sensor.

Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A375029C01
1.917,2.844 2.094,3.01 0.177,0.167 10 true *a 1.823,4.26 2,4.427 0.177,0.167 10 true *b 1.469,4.26 1.646,4.427 0.177,0.167 10 true *b
*a Front of Engine
*b 10°


Install the knock sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:

Make sure that the knock sensor is in the correct position.



b.

Connect the knock sensor connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing a knock sensor.

Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION