Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295710 HEATED OXYGEN SENSOR A

2ZR-FXE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344784

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

Hide 89465 2.REMOVE HEATED OXYGEN SENSOR

a.
A396246

Disengage the wire harness clamp.


b.

Remove the wire harness clamp bracket from the heated oxygen sensor.


c.
A396247N01
0.938,0.854 0.75,0.375 false 0.479,0.302 0.938,0.5 0.458,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly (TWC: Front and Rear Catalyst).

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.