Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2016.10–2018.05
RM32K0E _54 Brake _060048 PARKING BRAKE _0296497 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  U0073/51  Control Module Communication Bus OFF  U0100/53  Lost Communication with ECM/PCM  U0124/55  Lost Communication with Lateral Acceleration Sensor Module  U0129/52  Lost Communication with Brake System Control Module  U0293/54  Lost Communication with HV ECU  


DESCRIPTION

The parking brake ECU assembly communicates with the hybrid vehicle control ECU, skid control ECU (brake booster with master cylinder assembly) and deceleration sensor (airbag sensor assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
U0073/51 Control Module Communication Bus OFF Both of following conditions are met:
1.

Power switch on (IG)

2.

Bus is off (communication with other ECUs is not possible).


CAN communication system DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0100/53 Lost Communication with ECM/PCM Both of following conditions are met:
1.

Vehicle being driven at 15 km/h (9 mph) or more.

2.

Parking brake ECU assembly cannot receive signals from the ECM for approximately 1 second or 10 seconds (malfunction detection duration differs depending on the signal).


·

CAN communication system

·

ECM


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0124/55 Lost Communication with Lateral Acceleration Sensor Module Both of following conditions are met:
1.

Vehicle is being driven at 7 km/h (4.3 mph) or more.

2.

Parking brake ECU assembly cannot receive signals from the deceleration sensor (airbag sensor assembly).


·

CAN communication system

·

Deceleration sensor (Airbag sensor assembly)


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0129/52 Lost Communication with Brake System Control Module Both of following conditions are met:
1.

Power switch on (IG).

2.

Parking brake ECU assembly cannot receive signals from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or 10 seconds (malfunction duration differs depending on the signal).


·

CAN communication system

·

Skid control ECU (brake booster with master cylinder assembly)


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
U0293/54 Lost Communication with HV ECU Both of following conditions are met:
1.

Vehicle being driven at 15 km/h (9 mph) or more.

2.

Parking brake ECU cannot receive signals from the hybrid vehicle control ECU assembly for approximately 1 second or 10 seconds (malfunction detection duration differs depending on the signal).


·

CAN communication system

·

Hybrid vehicle control ECU


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

PROCEDURE

1.GO TO CAN COMMUNICATION SYSTEM

Result:
Proceed to
NEXT



NEXT

END