The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU. | ·
Electronically controlled brake system ·
Blind spot monitor sensor LH (Master) ·
Blind spot monitor sensor RH (Slave) |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Check for electronically controlled brake control system DTCs.
Electronically controlled brake control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the power switch off.
Turn the power switch on (IG).
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTC C1A45 is output ("Blind Spot Monitor Master"). | B |
| DTC C1A45 is output ("Blind Spot Monitor Slave"). | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C