The brake hold operated indicator light illuminates when the brake hold system is operating (vehicle stopped due to brake fluid pressure hold) and turns off when the brake hold system operation is finished (brake fluid pressure decreases).
The brake hold system may not operate depending on vehicle conditions even when the system is in standby mode and the brake hold standby indicator light is illuminated.
When a malfunction occurs in the brake control system, the brake hold operated indicator light blinks.
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
Check that the brake hold standby indicator light operates normally.
If the brake hold operated indicator light does not illuminate although the brake hold standby indicator light is illuminated, check that the following brake hold operation (maintaining brake oil pressure) conditions are met.
Shift position is not P or R.
Driver is depressing brake pedal and vehicle is fully stopped.
Driver is not depressing accelerator pedal.
Vehicle is not on steep decline.
When a malfunction occurs in the brake control system, the brake hold operated indicator light blinks.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch off.
Perform the Active Test of the combination meter assembly using the GTS.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display |
|---|
| Indicat. Hold |
Check the combination meter assembly.
The brake hold operated indicator light turns on or off in accordance with the GTS operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the power switch on (IG).
Select the Active Test on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| BH Operated Light | Brake hold operated indicator light | Indicator light ON/OFF | Observe combination meter |
Select the Data List on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| BH Operated Light | Brake hold operated indicator light | ON or OFF | ON: Indicator light on
OFF: Indicator light off |
- |
| Active Test Display |
|---|
| BH Operated Light |
| Data List Display |
|---|
| BH Operated Light |
Check the operating condition of the brake hold operated indicator light when operating it using the GTS.
| Result | Proceed to |
|---|---|
| Brake hold operated indicator light in the Data List does not change using the Active Test. (LHD) | A |
| Brake hold operated indicator light in the Data List does not change using the Active Test. (RHD) | B |
| Brake hold operated indicator light in the Data List turns ON/OFF using the Active Test. | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING