83530
1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the power switch on (IG).
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the engine oil pressure switch assembly connector.
Put the engine in inspection mode (maintenance mode).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE
Start the engine.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - Switch body | Idling | 10 kΩ or higher |
| Engine stopped | Below 1 Ω |
If the result is not as specified, replace the engine oil pressure switch assembly.
Connect the engine oil pressure switch assembly connector.