The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
|
|
| Disconnect cable from negative auxiliary battery terminal
|
Memorize steering angle neutral point
|
Lane departure alert system (w/ Steering Control)
|
( )
|
| Simple intelligent parking assist system*1
|
| Toyota parking assist-sensor system*1
|
| Pre-collision system
|
| Initialize back door lock
|
Power door lock control system
|
( )
|
| Replacement of inverter with converter assembly
|
Resolver learning
|
·
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
·
Shock or vibration during acceleration
|
( )
|
|
Perform Vehicle Identification Number (VIN) or frame number registration
|
MIL comes on
|
( )
|
for SFI system
·
Replacement of throttle body assembly
·
Replacement of engine assembly
·
Gas leak from exhaust system is repaired
|
Inspection After Repair
|
·
Engine start function, etc.
|
( )
|
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
Initialize No. 1 headlight ECU sub-assembly LH
|
Automatic headlight beam level control system
|
( )
|
| Front wheel alignment adjustment
|
1.
Clear zero point calibration data.
2.
Perform yaw rate and acceleration sensor zero point calibration.
|
·
ABS warning light illuminates
·
Brake warning light/yellow (minor malfunction) illuminates
·
Slip indicator light illuminates
·
VSC disabled or malfunctions
|
( )
|
| Replacement of hybrid vehicle transaxle assembly
|
|
·
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
·
Shock or vibration during acceleration
|
( )
|