Home › Engine / Hybrid System › 2ZR-FXE (STARTING) › POWER SWITCH (for RHD)
RM32K0E _51 Engine / Hybrid System _060219 2ZR-FXE STARTING _0300005 POWER SWITCH(for RHD) G

2ZR-FXE STARTING  POWER SWITCH(for RHD)  INSPECTION  


PROCEDURE

Hide 1.INSPECT POWER SWITCH

a.

Check the resistance

i.
B268088C19
0.781,0.792 1.229,1.156 true 2.177,1.188 2.573,0.833 true 2.188,1.406 2.542,1.708 true 2.646,0.76 3.104,0.958 0.458,0.198 10 false SS2 2.573,1.667 3.031,1.865 0.458,0.198 10 false AGND 0.49,0.729 0.948,0.927 0.458,0.198 10 false SS1 0.104,0.073 0.563,0.271 0.458,0.198 12 false *a
*a Component without harness connected
(Power Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND)
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND)


If the result is not as specified, replace the power switch.



b.

Check the LED illumination.

i.
B268088C20
1.042,1.865 1.458,1.448 true 2.198,1.427 2.542,1.76 true 0.76,1.781 1.375,1.979 0.615,0.198 10 true SWIL 2.583,1.719 3.198,1.917 0.615,0.198 10 false AGND 0.115,0.115 0.49,0.354 0.375,0.24 12 false *a
*a Component without harness connected
(Power Switch)


Apply auxiliary battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 9 (SWIL)
Auxiliary battery negative (-) → Terminal 6 (AGND)
Illuminates


If the result is not as specified, replace the power switch.