Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM32K0E _58 Vehicle Interior _061609 HEATING / AIR CONDITIONING _0300409 FRONT EVAPORATOR TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88625 1.INSPECT NO. 1 COOLER THERMISTOR

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

E338821C01
0.208,1.656 0.542,1.24 false 5.792,1.51 6.052,1.208 false 1.313,0.51 1.625,0.667 0.313,0.156 10 false *a 0.531,1.042 0.844,1.198 0.313,0.156 10 false *b 4.51,0.125 4.823,0.281 0.313,0.156 10 false *c 5.938,2.594 6.25,2.75 0.313,0.156 10 false *d 6.031,1.063 6.344,1.219 0.313,0.156 10 false *e 4.781,2.354 5.073,2.563 0.292,0.208 10 false (14) 5.333,2.354 5.646,2.594 0.313,0.24 10 false (32) 5.865,2.365 6.188,2.573 0.323,0.208 10 false (50) 6.396,2.375 6.677,2.646 0.281,0.271 10 false (68) 6.896,2.375 7.156,2.635 0.26,0.26 10 false (86)
*a Component without harness connected
(No. 1 Cooler Thermistor)
*b Sensing Portion
*c Resistance (kΩ) *d Temperature (°C (°F))
*e Allowable Range - -


Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -10°C (14°F) 7.30 to 9.10 kΩ
-5°C (23°F) 5.65 to 6.95 kΩ
0°C (32°F) 4.40 to 5.35 kΩ
5°C (41°F) 3.40 to 4.15 kΩ
10°C (50°F) 2.70 to 3.25 kΩ
15°C (59°F) 2.14 to 2.58 kΩ
20°C (68°F) 1.71 to 2.05 kΩ
25°C (77°F) 1.38 to 1.64 kΩ
30°C (86°F) 1.11 to 1.32 kΩ


If the resistance is not as specified, replace the No. 1 cooler thermistor.

NOTICE:
·

Hold the sensor only by its connector. Touching the sensing portion may change the resistance value.

·

When measuring, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph).


If the specified condition is not met, replace the No. 1 cooler thermistor.