81260A
1.INSPECT INTRUSION SENSOR CANCEL SWITCH (MAP LIGHT ASSEMBLY)
| *a | Component without harness connected
(Intrusion Sensor Cancel Switch (Map Light Assembly)) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 11 (SOFF) - 3 (GND) | Intrusion sensor cancel switch is pressed | Below 1 Ω |
| 11 (SOFF) - 3 (GND) | Intrusion sensor cancel switch is not pressed | 10 kΩ or higher |
If the resistance is not as specified, replace the intrusion sensor cancel switch (map light assembly).