When an electronic key transmitter sub-assembly switch is pushed: 1) the door control receiver receives the wireless door lock signal; 2) the door control receiver sends a signal to the main body ECU (multiplex network body ECU) through the certification ECU (smart key ECU assembly); 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motor assemblies; and 4) the power window regulator motor assemblies are activated.
When the driver door key cylinder (key linked switch) is turned and held: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motor assemblies; and 3) the power window regulator motor assemblies are activated.
These functions are set through customize settings, as they are off by default.
The power window control system uses the LIN communication system and CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication systems are functioning properly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check that power window system customize setting "Door Key P/W Up", "Door Key P/W Down", "P/W Up W/Transmit" and "P/W Down W/Transmit" are set to "ON" before performing the following procedure.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>CUSTOMIZE PARAMETERS
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
Check that the wireless door lock/unlock function operates normally.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
Check that the key-linked lock/unlock function operates normally.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
| Result | Proceed to |
|---|---|
| Wireless door lock/unlock function and key-linked lock/unlock function operate normally | A |
| Wireless door lock/unlock function does not operate normally | B |
| Key-linked lock/unlock function does not operate normally | C |
A
B
C
Check that the manual up and down functions using the multiplex network master switch assembly and power window regulator switch assembly can operate all of the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Manual up and down functions are normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the remote up and down functions using the multiplex network master switch assembly can operate all of the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Remote up and down functions are normal.
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C