Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM32K0E _55 Steering _061343 STEERING COLUMN _0299713 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness.

·

Do not allow any moisture to come into contact with the power steering ECU assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU assembly.



PROCEDURE

Hide 45020B 1.REMOVE STEERING LOCK ACTUATOR ASSEMBLY

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Using a center punch, mark the center of the tapered-head bolt.


c.

Using a 3 to 4 mm (0.119 to 0.157 in.) drill, drill a hole in the bolt.


d.
C322180

Using a screw extractor, remove the bolt and steering lock actuator assembly from the steering column sub-assembly.


Hide 89650 2.REMOVE POWER STEERING ECU ASSEMBLY (for LHD)

Hide 45254B 3.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for LHD)

Hide 89650 4.REMOVE POWER STEERING ECU ASSEMBLY (for RHD)

Hide 45254B 5.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for RHD)