Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM32K0E _55 Steering _061343 STEERING COLUMN _0299713 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness.

·

Do not allow any moisture to come into contact with the power steering ECU assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU assembly.



PROCEDURE

Hide 45254B 1.INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for LHD)

Hide 89650 2.INSTALL POWER STEERING ECU ASSEMBLY (for LHD)

Hide 45254B 3.INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for RHD)

Hide 89650 4.INSTALL POWER STEERING ECU ASSEMBLY (for RHD)

Hide 45020B 5.INSTALL STEERING LOCK ACTUATOR ASSEMBLY

HINT:

When replacing the steering lock actuator assembly, refer to the Service Bulletin.


a.
C322179

Install the steering lock actuator assembly with the tapered-head bolt.


b.

Tighten the tapered-head bolt until the bolt head breaks off.