Home › Steering › STEERING COLUMN › STEERING HEATER SWITCH
RM32K0E _55 Steering _061343 STEERING COLUMN _0299716 STEERING HEATER SWITCH G

STEERING COLUMN  STEERING HEATER SWITCH  INSPECTION  


PROCEDURE

Hide 84255 1.INSPECT STEERING HEATER SWITCH

a.

Check the resistance.

i.
C369024C01
1.083,1.771 1.5,1.354 true 2.469,1.729 2.094,1.354 true 0.063,0.073 0.375,0.271 0.313,0.198 10 false *a 0.906,1.688 1.219,1.885 0.313,0.198 10 false IG 2.542,1.677 2.854,1.875 0.313,0.198 10 false B
*a Component without harness connected
(Steering Heater Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (IG) - 6 (B) switch pushed Below 1 Ω
9 (IG) - 6 (B) switch not pushed 10 kΩ or higher


If the result is not as specified, replace the steering heater switch.



b.

Check that the illumination illuminates.

i.
C369024C02
1.302,1.781 1.719,1.365 true 2.354,1.75 1.917,1.365 true 0.083,0.052 0.396,0.25 0.313,0.198 10 false *a 0.979,1.688 1.594,1.885 0.615,0.198 10 false ILL+ 2.427,1.688 3.042,1.885 0.615,0.198 10 false ILL-
*a Component without harness connected
(Steering Heater Switch)


Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the steering heater switch.

Standard:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → 8 (ILL+) Auxiliary battery negative (-) → 7 (ILL-) Illuminates


If the result is not as specified, replace the steering heater switch.