This is the power source circuit to operate the radio receiver assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the radio receiver assembly connector.
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F48-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F48-4 (+B1) - F48-7 (GND1) | Always | 11 to 14 V |
| F48-3 (ACC1) - F48-7 (GND1) | power switch on (ACC). | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG