84922A
1.INSPECT FRONT LUMBAR POWER SEAT SWITCH
Check the resistance.
| *A | for LHD |
| *B | for RHD |
| *a | Front Lumbar Power Seat (Release) |
| *b | Front Lumbar Power Seat (Hold) |
| *c | Component without harness connected
(Front Lumbar Power Seat Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (H) - 2 (B) | Front lumbar power seat (Hold) pressed | Below 1 Ω |
| 3 (R) - 4 (E) | ||
| 5 (H) - 4 (E) | Off | |
| 3 (R) - 4 (E) | ||
| 3 (R) - 2 (B) | Front lumbar power seat (Release) pressed | |
| 5 (H) - 4 (E) |
If the result is not as specified, replace the front lumbar power seat switch.