Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM WARNING BUZZER (for RHD)
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0301355 PRE-COLLISION SYSTEM WARNING BUZZER(for RHD) G

PRE-COLLISION  PRE-COLLISION SYSTEM WARNING BUZZER(for RHD)  INSPECTION  


PROCEDURE

Hide 86652E 1.INSPECT PRE-COLLISION CITY BUZZER

a.

Make sure that there is no looseness in the locking part and connecting part of the connector.


b.

Disconnect the pre-collision city buzzer connector.


c.

Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.



d.
A303614

Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the pre-collision city buzzer, and check that the buzzer sounds.

OK:

The pre-collision city buzzer sounds.


If the result is not as specified, replace the pre-collision city buzzer.