Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY LH
2.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure as for the LH side.
3.REMOVE REAR SEAT ASSEMBLY
64330D
4.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
Disengage the hooks.
|
Remove in this Direction |
Disengage the guides to remove the package tray trim panel assembly as shown in the illustration.
64910J
5.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Disengage the hooks.
|
Remove in this Direction |
Disengage the guides to remove the tonneau cover assembly as shown in the illustration.
58410B
6.REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)
|
Hook and Loop Fastener |
|
Remove in this Direction |
for Type A:
Disengage the hook and loop fastener.
Remove the deck board assembly as shown in the illustration.
|
Remove in this Direction |
for Type B:
Remove the deck board assembly as shown in the illustration.
|
Remove in this Direction |
for Type C:
Remove the deck board assembly as shown in the illustration.
64777J
7.REMOVE SPARE WHEEL CUSHION (w/ Deck Board)
|
Remove in this Direction |
for Type A:
Remove the spare wheel cushion as shown in the illustration.
|
Remove in this Direction |
for Type B:
Remove the spare wheel cushion as shown in the illustration.
|
Remove in this Direction |
for Type C:
Remove the spare wheel cushion as shown in the illustration.
|
Remove in this Direction |
for Type D:
Remove the clip.
Remove the spare wheel cushion as shown in the illustration.
64997
8.REMOVE DECK FLOOR BOX LH (w/ Deck Floor Box)
|
Remove in this Direction |
for Type A:
Disengage the guide to remove the deck floor box LH as shown in the illustration.
|
Remove in this Direction |
for Type B:
Disengage the guide to remove the deck floor box LH as shown in the illustration.
64995
9.REMOVE DECK FLOOR BOX RH (w/ Deck Floor Box)
|
Remove in this Direction |
for Type A:
Disengage the guide to remove the deck floor box RH as shown in the illustration.
|
Remove in this Direction |
for Type B:
Disengage the guide to remove the deck floor box RH as shown in the illustration.
67914
10.REMOVE FRONT DOOR SCUFF PLATE LH
67913
11.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
62112
12.REMOVE COWL SIDE TRIM BOARD LH
62111C
13.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
62312B
14.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
15.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62212
16.REMOVE FRONT PILLAR GARNISH LH
62211
17.REMOVE FRONT PILLAR GARNISH RH
Use the same procedure as for the LH side.
67918A
18.REMOVE REAR DOOR SCUFF PLATE LH
|
Place Hands Here |
|
Remove in this Direction |
Disengage the claws to remove the rear door scuff plate LH as shown in the illustration.
67917A
19.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
76974F
20.REMOVE REAR UNDER SIDE COVER LH
|
Remove in this Direction |
Remove the 2 crips.
Disengage the clips, claw and guide to remove the rear under side cover LH as shown in the illustration.
76973F
21.REMOVE REAR UNDER SIDE COVER RH
Use the same procedure as for the LH side.
62332A
22.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
62331A
23.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
71304C
24.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH
Loosen the bolt and rear seatback hinge sub-assembly LH.
71303C
25.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
62552F
26.REMOVE REAR SEAT SIDE GARNISH LH
|
Place Hands Here |
|
Remove in this Direction |
Disengage the clip, claws and guide to remove the rear seat side garnish LH as shown in the illustration.
62551F
27.REMOVE REAR SEAT SIDE GARNISH RH
Use the same procedure as for the LH side.
73233
28.REMOVE LAP BELT OUTER ANCHOR COVER
73220
29.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
73210
30.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62414A
31.REMOVE CENTER PILLAR LOWER GARNISH LH
|
Place Hands Here |
|
Remove in this Direction |
Disengage the clips and claws to remove the center pillar lower garnish LH as shown in the illustration.
62413A
32.REMOVE CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side.
62420A
33.REMOVE CENTER PILLAR GARNISH ASSEMBLY LH
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the 2 clips.
Disengage the clip and guides to remove the center pillar garnish assembly LH as shown in the illustration.
When reusing the center pillar garnish assembly LH:
Remove the clip from the center pillar garnish assembly LH.
62410A
34.REMOVE CENTER PILLAR GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
64716D
35.REMOVE DECK TRIM REAR COVER
w/ Hook:
Remove the 2 bolts and 2 luggage hold belt strikers.
w/o Hook:
Remove the 2 clips.
|
Place Hands Here |
|
Remove in this Direction |
Disengage the clips, claws and guides to remove the deck trim rear cover as shown in the illustration.
81330
36.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
64715C
37.REMOVE DECK TRIM SIDE COVER LH (w/ Cover)
Turn the cover knob as shown in the illustration and unlock it.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the guides to remove the deck trim side cover LH as shown in the illustration.
64714C
38.REMOVE DECK TRIM SIDE COVER RH (w/ Cover)
Use the same procedure as for the LH side.
64740C
39.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
w/ Hook:
Remove the bolt and luggage hold belt striker.
w/o Hook:
Remove the clip.
|
Remove in this Direction |
Disengage the clips and claws to remove the deck trim side panel LH as shown in the illustration.
Disconnect the rear seat 3 point type outer belt assembly LH.
64730B
40.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Use the same procedure as for the LH side.
62480A
41.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the clips and guide to remove the roof side inner garnish assembly LH as shown in the illustration.
When reusing the roof side inner garnish assembly LH:
Remove the 5 clips from the roof side inner garnish assembly LH.
62470A
42.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
89943
43.REMOVE RAIN SENSOR COVER (w/ Rain Sensor)
86466E
44.REMOVE NO. 2 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)
86466D
45.REMOVE NO. 1 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)
87834
46.REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)
81340
47.REMOVE VANITY LIGHT ASSEMBLY (w/ Vanity Light)
81260A
48.REMOVE MAP LIGHT ASSEMBLY (w/ Map Light)
81240
49.REMOVE NO. 1 ROOM LIGHT ASSEMBLY (w/ Map Light)
89732A
50.REMOVE THEFT WARNING ULTRASONIC SENSOR (w/ Intrusion Sensor)
74325
51.REMOVE VISOR BRACKET COVER
Use the same procedures for the opposite side.
|
Remove in this Direction |
Using a molding remover A, disengage the claws to remove the visor bracket cover as shown in the illustration.
74320
52.REMOVE VISOR ASSEMBLY LH (w/ Vanity Light)
74310
53.REMOVE VISOR ASSEMBLY RH (w/ Vanity Light)
Use the same procedure as for the LH side.
74320
54.REMOVE VISOR ASSEMBLY LH (w/o Vanity Light)
Using a T10H "TORX" driver, remove the 2 screws.
Disengage the guide to remove the visor assembly LH.
74310
55.REMOVE VISOR ASSEMBLY RH (w/o Vanity Light)
Use the same procedure as for the LH side.
74348
56.REMOVE VISOR HOLDER
Use the same procedures for the opposite side.
|
Turn in this Direction |
|
Remove in this Direction |
Turn the holder clockwise approximately 45° and pull it out as shown in the illustration.
|
Remove in this Direction |
Disengage the claws to remove the base as shown in the illustration.
74612
57.REMOVE ASSIST GRIP COVER
Use the same procedures for the opposite side.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the 2 assist grip covers as shown in the illustration.
74610A
58.REMOVE ASSIST GRIP SUB-ASSEMBLY
Use the same procedures for the opposite side.
|
Remove in this Direction |
Disengage the clips to remove the assist grip sub-assembly as shown in the illustration.
Remove the 2 clips from the vehicle body.
63311C
59.REMOVE ROOF HEADLINING
for Front Pillar LH Side:
Disconnect the 2 connectors.
Using a clip remover, disengage the wire harness clamps.
for Front Pillar RH Side:
Disconnect the connector.
Using a clip remover, disengage the wire harness clamps.
for Rear Pillar RH Side:
Disconnect the connector.
| *A | w/ Lane Departure Alert System |
| *B | w/ EC Mirror |
| *C | w/ Rain Sensor |
for Windshield Glass Side:
Disconnect each connector.
for Roof Panel Side:
w/ Lane Departure Alert System:
Remove the nut to disconnect the ground wire.
w/ Digital Audio Broadcasting Antenna:
Using a clip remover, disengage the clamp to disconnect the wire harness.
Disconnect the connector.
Using a clip remover, remove the 3 clips.
Disengage the guides to remove the roof headlining.
|
Remove in this Direction |
Turn the roof headlining diagonally and bend slightly to remove it from the back door.
Make sure that wrinkles do not form in the roof headlining during removal.
Make sure that the roof headlining does not get caught on anything as it may become bent or damaged.
Do not damage the roof headlining or vehicle interior.