81260A
1.INSPECT MAP LIGHT ASSEMBLY
| *a | Component without harness connected
(Map Light Assembly) |
Check the map light.
Apply auxiliary battery voltage to the map light assembly and check that the map light comes on.
| Auxiliary battery Connection | Switch Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 12 (+B1)
Auxiliary battery negative (-) → 3 (GND) |
Map light switch LH on | Map light LH comes on |
| Map light switch LH off | Map light LH does not come on | |
| Map light switch RH on | Map light RH comes on | |
| Map light switch RH off | Map light RH does not come on | |
| Auxiliary battery positive (+) → 12 (+B1)
Auxiliary battery negative (-) → 10 (DOOR) |
Map light switch off and door switch on | Map light comes on |
| Map light switch off and door switch off | Map light does not come on |
If the result is not as specified, replace the map light bulb or map light assembly.
Check the door switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 10 (DOOR) - 4 (RLMP) | Door switch on | Below 1 Ω |
| Door switch off | 10 kΩ or higher |
If the result is not as specified, replace the map light assembly.
Check the switch illumination.
Apply auxiliary battery voltage to the map light assembly and check that the illumination comes on.
| Auxiliary battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → 2 (ILLB)
Auxiliary battery negative (-) → 3 (GND) |
Illumination comes on |
If the result is not as specified, replace the map light assembly.