Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH
RM32K0E _59 Vehicle Exterior _061311 WINDOW / GLASS _0302411 REAR POWER WINDOW SWITCH G

WINDOW / GLASS  REAR POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.
B429567C08
1.865,2.708 2.333,2.833 true 1.51,2.635 1.833,2.083 true 1.354,2.76 1.667,3.167 true 1.198,2.635 1,2 true 0.854,2.75 0.583,3.167 true 0.729,2.635 0.5,2.083 true 0.104,1.594 0.417,1.792 0.313,0.198 10 false *a 0.115,1.917 0.729,2.115 0.615,0.198 10 false AUTO 0.802,1.823 1.115,2.021 0.313,0.198 10 false UP 1.885,1.917 2.5,2.115 0.615,0.198 10 false ILL+ 2.396,2.74 3.01,2.938 0.615,0.198 10 false ILL- 1.719,3.115 2.333,3.313 0.615,0.198 10 false DOWN 0.24,3.115 0.698,3.313 0.458,0.198 10 false GND
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (UP) - 7 (GND) Auto up or up position Below 100 Ω
4 (DOWN) - 7 (GND) Auto down or down position Below 100 Ω
8 (AUTO) - 7 (GND) Auto up or auto down position Below 100 Ω
5 (UP) - 7 (GND) Off 10 kΩ or higher
4 (DOWN) - 7 (GND) Off 10 kΩ or higher
8 (AUTO) - 7 (GND) Off 10 kΩ or higher


If the result is not as specified, replace the rear power window regulator switch assembly.



b.

Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the power window regulator switch assembly and check that the LED illuminates.

OK:
Auxiliary battery Connection Specified Condition
Auxiliary battery positive (+) → 3 (ILL+)
Auxiliary battery negative (-) → 1 (ILL-)
LED illuminates


If the result is not as specified, replace the rear power window regulator switch assembly.