Do not apply positive (+) auxiliary battery voltage to any terminals, except terminal 2 (B), to avoid damaging the pulse sensor inside the motor.
Perform initialization of the power window system after removing, inspecting or replacing the power window regulator motor assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
1.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
| *a | Component without harness connected
(Power Window Regulator Motor Assembly LH) |
| *b | Clockwise |
| *c | Counterclockwise |
| *d | Motor Gear |
Connect a positive (+) auxiliary battery lead to connector terminal 2 (B).
Do not connect a positive (+) auxiliary battery lead to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.
Connect a negative (-) auxiliary battery lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
Check that the motor gear rotates smoothly as follows:
| Measurement Condition | Specified Condition |
|---|---|
1.
Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected, connect a negative (-) auxiliary battery lead to terminal 10 (UP). |
Motor gear rotates clockwise |
1.
Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected, connect a negative (-) auxiliary battery lead to terminal 7 (DOWN). |
Motor gear rotates counterclockwise |
If the result is not as specified, replace the power window regulator motor assembly LH.
Initialize the power window control system after installing the power window regulator motor and regulator assembly.
2.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
| *a | Component without harness connected
(Power Window Regulator Motor Assembly RH) |
| *b | Clockwise |
| *c | Counterclockwise |
| *d | Motor Gear |
Connect a positive (+) auxiliary battery lead to connector terminal 2 (B).
Do not connect a positive (+) auxiliary battery lead to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.
Connect a negative (-) auxiliary battery lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
Check that the motor gear rotates smoothly as follows:
| Measurement Condition | Specified Condition |
|---|---|
1.
Connect the positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected, connect a negative (-) auxiliary battery lead to terminal 10 (UP). |
Motor gear rotates counterclockwise |
1.
Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more. 2.
With terminals 2 (B) and 1 (GND) connected, connect a negative (-) auxiliary battery lead to terminal 7 (DOWN). |
Motor gear rotates clockwise |
If the result is not as specified, replace the power window regulator motor assembly RH.
Initialize the power window control system after installing the power window regulator motor and regulator assembly.