Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0302427 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.

The sound signal that has been sent is amplified by the radio and display receiver assembly and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

E360344E01
0.469,3.667 1.656,4.094 1.188,0.427 10 false No. 1 Stereo Jack Adapter Assembly 5.844,3.677 7.031,4.104 1.188,0.427 10 false Radio and Display Receiver Assembly 5.948,3.021 6.563,3.219 0.615,0.198 10 false AGND 0.833,3 1.448,3.198 0.615,0.198 10 false AGND 0.833,2.417 1.448,2.615 0.615,0.198 10 false ASGN 0.917,1.823 1.531,2.021 0.615,0.198 10 false ALO 0.917,1.229 1.531,1.427 0.615,0.198 10 false ARO 0.833,0.646 1.448,0.844 0.615,0.198 10 false AUXO 5.948,0.646 6.563,0.844 0.615,0.198 10 false ADPG 5.969,1.24 6.583,1.438 0.615,0.198 10 false VAR+ 5.958,1.833 6.573,2.031 0.615,0.198 10 false VAL+ 5.958,2.427 6.573,2.625 0.615,0.198 10 false VA- 5.677,2.906 5.99,3.104 0.313,0.198 10 false 11 5.688,2.302 6,2.5 0.313,0.198 10 false 27 5.688,1.708 6,1.906 0.313,0.198 10 false 28 5.688,1.094 6,1.292 0.313,0.198 10 false 26 5.688,0.521 6,0.719 0.313,0.198 10 false 25 1.333,2.885 1.646,3.083 0.313,0.198 10 false 10 1.333,2.292 1.646,2.49 0.313,0.198 10 false 8 1.323,1.688 1.635,1.885 0.313,0.198 10 false 7 1.323,1.104 1.635,1.302 0.313,0.198 10 false 6 1.323,0.5 1.635,0.698 0.313,0.198 10 false 9 0.479,3.458 0.792,3.656 0.313,0.198 10 false j1 5.854,3.49 6.417,3.667 0.563,0.177 10 false F125 3.271,2.833 4.448,3.083 1.177,0.25 10 false (Shielded)

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F125 radio and display receiver assembly connector.


b.

Disconnect the j1 No. 1 stereo jack adapter assembly connector.


c.
E227392C54
1.5,0.219 1.958,0.5 0.458,0.281 1.5,2.271 1.958,2.552 0.458,0.281 2.115,1.417 2.781,1.177 true 2.219,1.635 2.073,1.958 true 2.115,1.635 1.594,1.958 true 2.448,1.635 2.969,1.958 true 2.333,1.635 2.479,1.958 true 1.552,3.865 1.208,4.323 true 1.875,3.854 2.146,4.292 true 2.031,3.833 2.531,3.833 true 1.385,3.833 0.958,3.833 true 1.708,3.854 1.708,4.26 true 2.823,1.083 3.25,1.229 0.427,0.146 10 false AGND 1.813,1.979 2.323,2.365 0.51,0.385 10 false VAR+ 1.156,1.885 1.719,2.167 0.563,0.281 10 false ADPG 2.885,1.979 3.25,2.125 0.365,0.146 10 false VAL+ 2.417,1.979 2.667,2.125 0.25,0.146 10 false VA- 0.177,0.167 0.604,0.771 0.427,0.604 10 false *a 1.563,0.281 2.031,0.531 0.469,0.25 10 false F125 2.604,3.771 3.031,3.917 0.427,0.146 10 false AGND 1.042,4.323 1.365,4.469 0.323,0.146 10 false ALO 2.125,4.302 2.542,4.448 0.417,0.146 10 false AUXO 0.177,2.229 0.563,2.542 0.385,0.313 10 false *b 0.635,3.75 0.99,3.896 0.354,0.146 10 false ARO 1.563,4.292 1.99,4.438 0.427,0.146 10 false ASGN 1.667,2.323 2.167,2.583 0.5,0.26 10 false j1
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F125-25 (ADPG) - j1-9 (AUXO) Always Below 1 Ω
F125-11 (AGND) - j1-10 (AGND) Always Below 1 Ω
F125-26 (VAR+) - j1-6 (ARO) Always Below 1 Ω
F125-28 (VAL+) - j1-7 (ALO) Always Below 1 Ω
F125-27 (VA-) - j1-8 (ASGN) Always Below 1 Ω
F125-25 (ADPG) - Body ground Always 10 kΩ or higher
F125-11 (AGND) - Body ground Always 10 kΩ or higher
F125-26 (VAR+) - Body ground Always 10 kΩ or higher
F125-28 (VAL+) - Body ground Always 10 kΩ or higher
F125-27 (VA-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR