Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0302427 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Vehicle Speed Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E261261E56
1.219,1.115 1.833,1.313 0.615,0.198 10 false SPDO 5.531,1.115 6.146,1.313 0.615,0.198 10 false SPD 1.719,0.99 2.333,1.188 0.615,0.198 10 false 2 5.323,1 5.646,1.198 0.323,0.198 10 false 5 0.5,1.948 1.115,2.146 0.615,0.198 10 false F80 0.51,2.104 2.292,2.469 1.781,0.365 10 false Radio and Display Receiver Assembly 5.427,2 6.042,2.198 0.615,0.198 10 false F83 5.427,2.156 6.417,2.396 0.99,0.24 10 false Navigation ECU

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the F80 radio and display receiver assembly connector.


b.

Disconnect the F83 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F80-2 (SPDO) - F83-5 (SPD) Always Below 1 Ω
F80-2 (SPDO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR