RM32K0E
_V1
General
_059401
SPECIFICATIONS
_0303193
P610 HYBRID TRANSMISSION / TRANSAXLE
F
SPECIFICATIONS P610 HYBRID TRANSMISSION / TRANSAXLE SERVICE DATA
Hybrid Transaxle System
| Maintenance mode engine idle speed
|
Hybrid transaxle fluid temperature
|
Hybrid transaxle fluid pressure
|
| 900 to 1000 rpm
|
20 to 50°C (68 to 122°F)
|
10 kPa (0.1 kgf/cm2, 1.5 psi) or more
|
Hybrid Transaxle Fluid
| Hybrid transaxle fluid standard capacity (for Reference)
|
Classification
|
| 3.6 liters (3.8 US qts, 3.2 Imp. qts)
|
Toyota Genuine ATF WS
|
Hybrid Transaxle Oil Seal
| Front drive shaft oil seal RH
|
Standard depth
|
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
|
| Front drive shaft oil seal LH
|
Standard depth
|
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
|
Input Shaft Oil Seal
| Input shaft type T oil seal
|
Standard depth
|
1.0 to 1.8 mm (0.0394 to 0.0709 in.)
|
Shift Lever
| Shift lock control unit assembly
|
| Wire harness
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 5 (IG) - Body ground
|
Power switch on (IG)
|
11 to 14 V
|
| Power switch off
|
Below 1 V
|
| 4 (STP) - Body ground
|
Brake pedal depressed
|
11 to 14 V
|
| Brake pedal released
|
Below 1 Ω
|
| 1 (E) - Body ground
|
Always
|
Below 1 Ω
|
| Shift lock solenoid
|
| 1 (SLS+) - 2 (SLS-)
|
Always
|
112 Ω
|
| 4 (P) - 3 (E2)
|
Shift lever in P
|
10 kΩ or higher
|
| Shift lever not in P
|
Below 1 Ω
|
| Transmission control switch (for LHD)
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 1 (SFTD) - 2 (E)
|
Shift lever held in "-" (Down-shift)
|
Below 1 Ω
|
| Shift lever not in "-"
|
10 kΩ or higher
|
| 3 (SFTU) - 2 (E)
|
Shift lever held in "+" (Up-shift)
|
Below 1 Ω
|
| Shift lever not in "+"
|
10 kΩ or higher
|
| Transmission control switch (for RHD)
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 3 (SFTD) - 2 (E)
|
Shift lever held in "-" (Down-shift)
|
Below 1 Ω
|
| Shift lever not in "-"
|
10 kΩ or higher
|
| 1 (SFTU) - 2 (E)
|
Shift lever held in "+" (Up-shift)
|
Below 1 Ω
|
| Shift lever not in "+"
|
10 kΩ or higher
|
Shift lever Position Sensor
| Shift lever Position Sensor
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 7 (+B) - 1 (DB1)
|
Shift lever in D or B
|
Below 1 Ω
|
| Shift lever not in D and B
|
10 kΩ or higher
|
| 7 (+B) - 2 (N)
|
Shift lever in N
|
Below 1 Ω
|
| Shift lever not in N
|
10 kΩ or higher
|
| 7 (+B) - 3 (PR)
|
Shift lever in P or R
|
Below 1 Ω
|
| Shift lever not in P and R
|
10 kΩ or higher
|
| 7 (+B) - 4 (PNB)
|
Shift lever in P, N or B
|
Below 1 Ω
|
| Shift lever not in P, N and B
|
10 kΩ or higher
|
| 7 (+B) - 6 (DB2)
|
Shift lever in D or B
|
Below 1 Ω
|
| Shift lever not in D and B
|
10 kΩ or higher
|
| 7 (+B) - 8 (P)
|
Shift lever in P
|
Below 1 Ω
|
| Shift lever not in P
|
10 kΩ or higher
|
| 7 (+B) - 9 (R)
|
Shift lever in R
|
Below 1 Ω
|
| Shift lever not in R
|
10 kΩ or higher
|