Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0303239 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM D

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the simple intelligent parking assist system may not operate correctly.


PRECAUTION (PROCEDURE 1)


a.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during simple intelligent parking assist system removal/installation are shown below.

For the installation location of the ultrasonic sensors, refer to Parts Location.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>PARTS LOCATION

Part Name Operation Adjustment Item Proceed to
Steering sensor
·

Removal and installation of the steering sensor

·

Removal and installation of the connector of the steering sensor

·

Replacement


Steering angle neutral point (Initialize simple intelligent parking assist system)* Procedure 2
Clearance warning ECU assembly Replacement Steering angle neutral point Procedure 2
Bumper type registration
Auxiliary battery Disconnect the cable from the negative (-) battery terminal, or remove the fuse for the simple intelligent parking assist system, etc. ("System Unavailable" is displayed on the multi-informationdisplay) Steering angle neutral point* Procedure 2

*: The steering sensor zero point can also be calibrated by driving the vehicle.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>INITIALIZATION




REGISTRATION (PROCEDURE 2)


a.

Preparation

i.

Confirm that the following DTCs are not output.

System Proceed to
Simple Intelligent Parking Assist System (Click here)
TOYOTA parking assist-sensor system (Click here)

NOTICE:

If DTC C1AEA or C168D are output at this point, it is not a malfunction. Proceed with the calibration.




b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Check that the steering wheel is centered (approximately +/- 5 degrees or less).

NOTICE:

Make sure that the wheels are positioned straight ahead.



e.

Turn the GTS on.


f.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility.

Body Electrical > IPA/ICS/Clearance Sonar > Utility
Tester Display
Clearance Sonar Detection/Steering Adjustment
50005 170 4402

g.

According to the display on the GTS, perform calibration.

HINT:

If "Battery or Steering Sensor" is selected, further calibration is not required. (Bumper type registration is not required.)



h.

Enter the bumper type using the GTS.

Bumper Type Value
Standard 1

HINT:

If the clearance warning ECU assembly is replaced or removed and installed, it is necessary to perform bumper type registration.



i.

Disconnect the GTS from the DLC3.