Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0303239 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  C1645  Power Steering Control System Failure  


DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a power steering system malfunction signal from the power steering ECU assembly via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1645 Power Steering Control System Failure Power steering system malfunction Power steering system

PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

No DTCs are output.


HINT:
·

This DTC is stored when a malfunction occurs in the power steering system.

·

This DTC may be output due to a temporary phenomenon such as low voltage or EPS overheat protection.

·

If troubleshooting and repair of a malfunction in the power steering system has been completed, DTC C1645 will not be output again when rechecking for DTCs.

·

If DTC C1645 is output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.




Result:
Proceed to
OK
NG



OK

NG