Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0303239 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  Vehicle does not Move to Set Parking Position  


PROCEDURE

1.CHECK TIRE SIZE
a.

Check that the tire pressure and tire size are as specified.


b.

Check that there is no excessive wear on the tires.


Result:
Result Proceed to
Tire size is as specified and there is no excessive wear A
Tire size is not as specified but there is no excessive wear
Tire size is as specified but there is excessive wear B
Tire size is not as specified and there is excessive wear
Tire size is totally different from specified size



A

2.CHECK TIRE ROTATION

B

REPLACE TIRES

2.CHECK TIRE ROTATION
a.

Check tire movement distance.

E127424C03
3.518,0.18 3.697,0.36 0.179,0.179 10 *a 5.913,0.54 6.093,0.684 0.179,0.145 10 *b 3.518,2.338 3.697,2.517 0.179,0.179 10 *c 5.367,1.805 5.815,0.608 5.815,0.608 5.899,0.608 false
*a 5 Rotations *b Chalk Mark
*c Movement Distance (A) - -


i.

On a level surface, center the steering wheel and stop the vehicle.


ii.

Apply chalk to a point on the tire and on the ground.


iii.

Drive the vehicle straight ahead, and stop the vehicle after the tire rotates 5 times.


iv.

Mark the vehicle stop position on the ground, and measure the movement distance (A). Check that the measured distance is within the standard range.

OK:

9565 to 9955 mm (31.37 to 32.65 ft.)




Result:
Proceed to
OK
NG



OK

3.CHECK WHEEL ALIGNMENT

NG

REPLACE TIRES

3.CHECK WHEEL ALIGNMENT
a.

Perform the front wheel alignment inspection.

HINT:

For alignment inspection, follow the toe-in and camber specifications.

Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT


OK:

Alignment is within specifications.



b.

Perform the rear wheel alignment inspection.

HINT:

For alignment inspection, follow the toe-in and camber specifications.

Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>REAR WHEEL ALIGNMENT>ADJUSTMENT


OK:

Alignment is within specifications.



Result:
Proceed to
OK
NG



OK

NG