Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2016.10–2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0303369 LIGHTING SYSTEM Y

LIGHTING (EXT)  LIGHTING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the lighting system.


·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
Result:
Proceed to
NEXT



NEXT

3.INSPECT AUXILIARY BATTERY
3.INSPECT AUXILIARY BATTERY
a.

Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V



If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

4.INSPECT CAN COMMUNICATION SYSTEM*
4.INSPECT CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B



A

5.CHECK FOR DTC*

B

5.CHECK FOR DTC*
a.

Connect the GTS to the DLC3.


b.

Turn the power switch to on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main body or HL AutoLeveling (for LED Headlight) / Trouble Codes.


e.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123
Body Electrical > HL AutoLeveling > Trouble Codes
50001 361

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

6.PROBLEM SYMPTOMS TABLE

B

GO TO DIAGNOSTIC TROUBLE CODE CHART (LIGHTING SYSTEM)

6.PROBLEM SYMPTOMS TABLE
a.

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.OVERALL ANALYSIS AND TROUBLESHOOTING*


c.

Inspection


d.

On-vehicle Inspection


Result:
Proceed to
NEXT



NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END