Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0303371 TOYOTA PARKING ASSIST-SENSOR SYSTEM C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  U0073  Control Module Communication Bus "A" Off  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0155  Lost Communication With Instrument Panel Cluster (IPC) Control Module  U0293  Lost Communication With Hybrid Powertrain Control Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0073 Control Module Communication Bus "A" Off Control module communication bus off CAN communication system
U0100 Lost Communication with ECM / PCM "A" Lost communication with ECM CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with steering sensor CAN communication system
U0129 Lost Communication with Brake System Control Module Lost communication with skid control ECU CAN communication system
U0155 Lost Communication With Instrument Panel Cluster (IPC) Control Module Lost communication with meter circuit plate CAN communication system
U0293 Lost Communication With Hybrid Powertrain Control Module Lost communication with hybrid vehicle control ECU CAN communication system

PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

No DTCs are output.


HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.




Result:
Proceed to
OK
NG



OK

NG