Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM32K0E _55 Steering _061342 POWER ASSIST SYSTEMS _0303420 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1541  Vehicle Speed Signal  


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the skid control ECU (brake booster with master cylinder assembly) via CAN communication. The ECU provides appropriate assist force in accordance with the vehicle speed based on the signals.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1541 Vehicle Speed Signal Vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Brake control system

·

CAN communication system

·

Power steering ECU assembly


EPS warning light: Comes on The ECU judges the system has returned to normal or the power switch is turned on (IG) again -

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Result Proceed to
DTC U0129 is not output. A
DTC U0129 is output. B



A

2.CHECK BRAKE CONTROL SYSTEM

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK BRAKE CONTROL SYSTEM
a.

Using the GTS, check for DTCs and confirm that there are no malfunctions in the brake control system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output. (for LHD) A
DTCs are not output. (for RHD) B
DTCs are output. C



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE POWER STEERING ECU ASSEMBLY

C