86150
1.INSPECT NO. 1 SPEAKER ASSEMBLY WITH BOX
Check the resistance.
| *a | Component without harness connected
(No. 1 Speaker Assembly with Box) |
Measure the resistance according to thevalue(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (WF+) - 2 (WF-)
3 (WF+) - 1 (WF-) |
Always | 10 kΩ or higher |
| 1 (WF-) - 2 (WF-) | Always | Below 1 Ω |
| 3 (WF+) - 4 (WF+) | Always | Below 1 Ω |
If the result is not as specified, replace the No. 1 speaker assembly with box.