86160J
1.INSPECT FRONT NO. 3 SPEAKER ASSEMBLY
Check the resistance.
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected
(Front No. 3 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (TWR+) - 4 (TWR-) | Always | 10 kΩ or higher |
| 1 (+) - 3 (-) | Always | 10 kΩ or higher |
| 1 (+) - 2 (TWR+) | Always | Below 1 Ω |
| 3 (-) - 4 (TWR-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (TWL+) - 4 (TWL-) | Always | 10 kΩ or higher |
| 1 (+) - 3 (-) | Always | 10 kΩ or higher |
| 1 (+) - 2 (TWL+) | Always | Below 1 Ω |
| 3 (-) - 4 (TWL-) | Always | Below 1 Ω |
If the result is not as specified, replace the front No. 3 speaker assembly.