86160P
1.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (w/ Woofer)
Check the resistance.
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (+) - 1 (-) | Always | 6.8 to 10.2 Ω |
If the result is not as specified, replace the front No. 2 speaker assembly.
86160P
2.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (w/o Woofer)
Check the resistance.
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (TWR+) - 2 (TWR-) | Always | 10 kΩ or higher |
| 1 (-) - 2 (TWR-) | Always | Below 1 Ω |
| 3 (+) - 4 (TWR+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (TWL+) - 2 (TWL-) | Always | 10 kΩ or higher |
| 1 (-) - 2 (TWL-) | Always | Below 1 Ω |
| 3 (+) - 4 (TWL+) | Always | Below 1 Ω |
If the result is not as specified, replace the front No. 2 speaker assembly.