If the new key registration warning message is not displayed after an electrical key transmitter sub-assembly has been registered, there may be communication problem between the certification ECU (smart key ECU assembly) and combination meter assembly (meter ECU).
The entry and start system (for Entry Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.
When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
Before replacing the certification ECU (smart key ECU assembly), refer to Precaution.
After repair, confirm that no DTCs are output.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Door Courtesy SW | Front door RH courtesy light switch signal | ON or OFF | ON: Front door RH open
OFF: Front door RH closed |
for RHD |
| FL Door Courtesy SW | Front door LH courtesy light switch signal | ON or OFF | ON: Front door LH open
OFF: Front door LH closed |
for LHD |
| Tester Display |
|---|
| FR Door Courtesy SW |
| FL Door Courtesy SW |
| Result | Proceed to |
|---|---|
| On the GTS screen, ON or OFF is displayed accordingly. | A |
| On the GTS screen, ON or OFF is not displayed accordingly. | B |
A
B
With all of the doors closed, lock the doors using the entry lock function and check that the warning message is displayed on the multi-information display.
Warning function (door ajar warning)
| Result | Proceed to |
|---|---|
| The warning message is displayed on the multi-information display. | A |
| The warning message is not displayed on the multi-information display. | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Clear all of the registered electrical key transmitter sub-assemblies except one and perform registration again.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
With all of the doors closed, lock the doors using the entry lock function.
Unlock the doors using the entry unlock function, open the driver door and check that the warning message is displayed on the multi-information display.
Warning function (An electrical key transmitter sub-assembly has been registered)
| Result | Proceed to |
|---|---|
| The warning message is displayed on the multi-information display. | A |
| The warning message is not displayed on the multi-information display. | B |
A
B