Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2016.10–2018.05
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0303861 PRE-COLLISION SYSTEM D

PRE-COLLISION  PRE-COLLISION SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.

Master Warning Indicator Warning Message Detail DTC PCS warning light
Illuminated "Pre-Collision System Malfunction Visit Your Dealer" Pre-collision system malfunctioning Stored Blinks
Not illuminated "Pre-Collision System Unavailable" Millimeter wave radar sensor assembly misaligned Not stored Illuminated
Not illuminated "Pre-Collision System Unavailable Clean Sensor" Foreign matter attached to millimeter wave radar sensor assembly Not stored Illuminated
Not illuminated "Front Camera Unavailable"
·

Abnormal forward recognition camera voltage

·

Forward recognition camera temperature outside of operational range


Not stored Illuminates
Not illuminated "Front Camera Vision Blocked. Clean and Demist Windshield" Foreign matter attached to forward recognition camera or area of windshield in front of forward recognition camera Not stored Illuminates
Not illuminated "VSC Turned Off Pre-Collision Brake System Unavailable" VSC system is disabled Not stored Illuminates

HINT:
PCS Warning Light Illumination Status
PCS Warning Light Condition
Blinks ON: 0.5 sec./OFF: 1.5 sec. Pre-collision system malfunctioning (DTC stored)
Illuminates Pre-collision system temporarily disabled
Pre-collision system disabled
VSC system disabled
Not illuminated Other




INITIAL CHECK


a.

An initial check is performed when the power switch is off for more than 2 seconds and then turned on (IG). The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.


b.

If a malfunction is detected during the initial check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.



CONSTANT CHECK


a.

The millimeter wave radar sensor assembly constantly monitors the pre-collision system for malfunctions after the power switch is turned to on (IG) and the initial check (approximately 3 seconds) has completed.


b.

If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.