Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2016.10–2020.08
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0303861 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U023A  Lost Communication with Front Camera Module  U0293  Lost Communication with HV ECU  


DESCRIPTION

These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-collision control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0125 Lost Communication with Yaw Rate Sensor Module When the driving the vehicle at a speed of 5 km/h, a communication error between the yaw rate and acceleration sensor (airbag sensor assembly) and the millimeter wave radar sensor assembly is detected for approximately 1 second.
·

CAN communication system

·

Yaw rate and acceleration sensor (Airbag sensor assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0126 Lost Communication with Steering Angle Sensor Module When the power switch to on (IG), a communication error between the steering angle sensor (spiral cable with sensor sub-assembly) and the millimeter wave radar sensor assembly is detected for approximately 4 seconds.
·

CAN communication system

·

Steering angle sensor (Spiral cable with sensor sub-assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0129 Lost Communication with Brake System Control Module When the power switch to on (IG), a communication error between the skid control ECU (brake actuator assembly) and the millimeter wave radar sensor assembly is detected for approximately 3 seconds.
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U023A Lost Communication with Front Camera Module After the power switch is turned to on (IG), a communication malfunction occurs between the millimeter wave radar sensor assembly and forward recognition camera.
·

CAN communication system

·

Forward recognition camera

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0293 Lost Communication with HV ECU When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the hybrid vehicle control ECU and the driving support ECU assembly is detected for approximately 5 seconds.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Millimeter wave radar sensor assembly

·

Wire harness or connector



PROCEDURE

1.CHECK FOR DTCs (PRE-COLLISION SYSTEM)
a.

Clear the DTCs.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Collision 2 > Clear DTCs
50002 220

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Collision 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC U0125, U126, U0129 and U0293 are not output A
DTC U0125, U126, U0129 and U0293 is output B



A

B