Be sure to correctly follow the removal and installation procedures for the airbag sensor assembly.
89170
1.INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
Perform a diagnostic system check.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
89170
2.INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
Visually check for defects with the airbag sensor assembly installed to the vehicle.
The defects are as follows:
Cracks in the ECU housing
Dents in the ECU housing
Chips in the ECU housing
Cracks or other damage to the connectors
Peeling of the label
No defects are found.
If any defects are found, replace the airbag sensor assembly with a new one.
89170
3.INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
Replace the airbag sensor assembly.
The airbag sensor assembly should be replaced after any of the SRS parts has deployed, as it has been subjected to an impact.