1.REMOVE REAR BUMPER ASSEMBLY
89342B
2.REMOVE REAR SIDE ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Disconnect the connector.
|
Remove in this Direction |
Disengage the claws to remove the rear side ultrasonic sensor as shown in the illustration.
89342
3.REMOVE REAR CORNER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Disconnect the connector.
|
Remove in this Direction |
Disengage the claws to remove the rear corner ultrasonic sensor as shown in the illustration.
89342A
4.REMOVE REAR CENTER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Disconnect the connector.
|
Remove in this Direction |
Disengage the claws to remove the rear center ultrasonic sensor as shown in the illustration.
89348T
5.REMOVE REAR SIDE ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the rear side ultrasonic sensor retainer is necessary.
When removing the rear side ultrasonic sensor retainer, heat the rear bumper assembly and rear side ultrasonic sensor retainer using a heat light.
Heat the rear bumper assembly and rear side ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Rear Side Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the 2 rear side ultrasonic sensor retainers.
89348R
6.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the rear corner ultrasonic sensor retainer is necessary.
When removing the rear corner ultrasonic sensor retainer, heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light.
Heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Rear Corner Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the 2 rear corner ultrasonic sensor retainers.
89348S
7.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the rear center ultrasonic sensor retainer is necessary.
When removing the rear center ultrasonic sensor retainer, heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.
Heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Rear Center Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the 2 rear center ultrasonic sensor retainers.